Crusher Fines And Processing Plant

The importance Processing plants have Crusher Fines

Fines Crusher products with high crushing ratio, uniform particle size of the material, simple structure, reliable performance, easy maintenance, operating and economic characteristics. In the process of crushing crushing chamber depth and no dead zone, can increase the feed capacity and output; relatively uniform particle size, and there are gasketed nesting population adjustment device, adjust the position of the gasket, the height increases the flexibility of the device , nesting population adjustment range is relatively large, it can meet most customers' needs.

Factors advantage Fine Crusher and impact of their normal work

Fines Crusher is mainly used for a variety of ores and medium-grained bulk materials broken, the highest compressive strength of the material to be broken up 320MPa, full jaw crusher is widely used in mining, smelting, building material, highway, railway, water conservancy, chemical , medium-grained cement, refractories and ceramics and other industries in a variety of ore crushing and bulk materials, especially for various mid-hard ores and rocks better crushing effect. Factors affecting the Crusher Fines has a lot to work properly.

First, the nip angle of Fine Crusher. Nip angle is the angle between the two crushing components, the greater the mine mouth rodents smaller row, crushing than the smaller, more easily through the ore, the greater production capacity.

Secondly, parallel, the longer parallel with the crushed ore width longer, the greater the capacity.

Third, the physical characteristics of the ore. As we all know, when you make a greater hardness ore production capacity is low; ore more brittle when it is easily broken; higher production capacity density calculated by weight; material in the proportion of larger grains rent efficiency is relatively low; The lower the crushing larger processing capabilities.

Finally, the number of revolutions of the Fine Crusher. Revolution is the ability to have a direct impact on production factors, in general, improve the number of revolutions can increase processing capacity, but to improve the margin should have been crushed ore to ensure there is enough time to discharge principle.


Supply the most current design and technical expertise; Supply parts sales and training service far beyond the initial sale; Your profits with quality parts and expert service.

+86-21-58386189, 58386176
Fax: +86-21-58386211


Please fill in your name and your message and do not forget mail and/or phone if you like to be contacted. Please note that you do not need to have a mail programme to use this function.